1
Restoration / Re: H 12 1/2 Winch - where did it go?
« on: September 11, 2015, 09:14:48 PM »
I think I have your answer for this one... My boat had two of these, and they were mounted on the forward bulkhead (see photo below showing the screws in the triangular pattern of the winch base protruding from the back side of the bulkhead beam next to the mast hole). Presumably they were to tighten the main and jib halyards given their position, which is peculiar, because the jib certainly does not require a winch to tighten, and the issue with tightening the main is more of the line stretching than the amount of force you can apply by hand alone. Besides, with the design of the pulley the way it is on the top of the mast, I wouldn't want to tighten it too much and split the mast up there.
